Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands I-M
▀ iups-service
▄ Command Line Interface Reference, StarOS Release 18
2618
iups-service
Creates an Iu-PS service instance and enters the Iu-PS Service Configuration Mode. This mode defines the
configuration and usage of Iu-PS interfaces between the SGSN and the RNCs in the UMTS radio access network
(UTRAN). It defines both the control plane (GTP-C) and the data plane (GTP-U) between these nodes.
configuration and usage of Iu-PS interfaces between the SGSN and the RNCs in the UMTS radio access network
(UTRAN). It defines both the control plane (GTP-C) and the data plane (GTP-U) between these nodes.
Important:
For details about the commands and parameters for this mode, check the IuPS Service Configuration
Mode Commands chapter.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] iups-service srvc_name
no
Remove the configuration for the specified Iu-PS service from the configuration for the current context.
srvc_name
Specifies the IuPS service name as a unique alphanumeric string of 1 through 63 characters.
Important:
Service names must be unique across all contexts within a chassis.
Usage
Use this command to create, edit, or remove an Iu-PS service. Add up to eight definitions to be used with a
single SGSN service so the SGSN can support multiple PLMNs.
single SGSN service so the SGSN can support multiple PLMNs.
Example
The following command creates an Iu-PS service named
iu-ps1
:
iups-service iu-ps1
The following command removes the Iu-PS service named
iu-ps1
:
no iups-service iu-ps1