Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands N-R
route-access-list standard ▀
Command Line Interface Reference, StarOS Release 18 ▄
2765
route-access-list standard
Configures an access-list for filtering routes based on network addresses.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] route-access-list standard identifier { permit | deny } { ip_address wildcard_mask
| any | host network_address }
| any | host network_address }
no
Deletes the specified route access list.
identifier
Specifies a value that identifies the route-access-list as an integer from 1 through 99.
deny
Denies routes that match the specified criteria.
permit
Permits routes that match the specified criteria.
ip_address wildcard_mask
Specifies the IP address and subnet mask to match for routes. Both
ip_address
and
wildcard_mask
must
be entered in IPv4 dotted-decimal notation. (For example, 192.168.100.0 255.255.255.0)
any
Matches any route.
host network_address
Matches only route shaving the specified network address as if it had a 32-bit network mask.
network_address
must be an IPv4 address specified in dotted-decimal notation.