Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (A-C)
card halt ▀
Command Line Interface Reference, StarOS Release 18 ▄
3803
card halt
Halts all StarOS processes on a card. A
card reboot
command must be issued to bring the card back into service after
it is halted. (ASR 5x00 only)
Product
All
Privilege
Security Administrator, Administrator, Operator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
card halt slot_num [ -force ] [ -noconfirm ]
slot_num
Indicates the slot number of the card of interest.
-force
Over-rides any warnings to force the card to be halted.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Halt a card to stop the card for maintenance or emergency situations.
Caution:
Caution should be taken in using this command. Halting a card which has no redundant card available
may cause a service interruption and loss of active sessions.
Important:
On the ASR 5500, do not initiate a card halt for an active FSC if there are less than two active FSCs
in the system. The system returns an error message if there are less than four active FSCs.
Caution:
The
-force
and
-noconfirm
options should only be used concurrently by experienced users as this
will cause an immediate halt regardless of warnings and no confirmation from the user.
Important:
This command is not supported on all platforms.
Example
The following command temporarily stops the card in slot 1.