Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Charging Action Configuration Mode Commands
▀ charge-volume
▄ Command Line Interface Reference, StarOS Release 18
398
charge-volume
This command allows you to configure how the volume amount counter for eG-CDRs, UDRs, and DCCA charging are
calculated.
calculated.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
charge-volume { { dns | ftp-control | ftp-data | http | icmp | imap | ip | mms | pop3 |
pptp | rtcp | rtp | rtsp | sdp | secure-http | sip | smtp | tcp | tftp | udp | wsp | wtp
} { bytes | packet-length | packets } [ downlink | uplink ] | constant fixed_value }
pptp | rtcp | rtp | rtsp | sdp | secure-http | sip | smtp | tcp | tftp | udp | wsp | wtp
} { bytes | packet-length | packets } [ downlink | uplink ] | constant fixed_value }
{ default | no } charge-volume
default
Configures this command with its default setting.
Default:
Default:
charge-volume ip bytes
no
If previously configured, deletes the charge-volume configuration in the current charging action.
{ dns | ftp-control | ftp-data | http | icmp | imap | ip | mms | pop3 | pptp |
rtcp | rtp | rtsp | sdp | secure-http | sip | smtp | tcp | tftp | udp | wsp | wtp
}
rtcp | rtp | rtsp | sdp | secure-http | sip | smtp | tcp | tftp | udp | wsp | wtp
}
Specifies the charge volume method for the specific rule definition.
dns
: Charge volume for DNS
ftp-control
: Charge volume for FTP-Control
ftp-data
: Charge volume for FTP-Data
http
: Charge volume for HTTP
icmp
: Charge volume for ICMP
imap
: Charge volume for Internet Message Access Protocol (IMAP)
ip
: Charge volume for IP
mms
: Charge volume for MMS
pop3
: Charge volume for POP3
pptp
: Charge volume for PPTP