Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (D-S)
egtpc test echo ▀
Command Line Interface Reference, StarOS Release 18 ▄
4093
egtpc test echo
Tests the ability of a GGSN/P-GW service to exchange GTP-C echo request messages with specified peer(s).
Product
GGSN
P-GW
SAEGW
Privilege
Operator, Config-Administrator, Administrator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
egtpc test echo gtp-version version src-address ip_address { all | peer-address
ip_address }
ip_address }
gtp-version version
Specifies version number for sending Echo request message.
version
must be an integer from 0 through 2.
Important:
If peer is not a new peer for service bind to
src-address
, then echo request is sent with the last
known highest version of the peer.
src-address
ip_address
Specifies the IP address of a Gn interface configured on the system.
ip_address
must be entered using IPv4 dotted-decimal notation or IPV6 colon-separated-hexadecimal
notation.
Important:
The IP address of the system’s Gn interface must be bound to a configured GGSN/P-GW service
prior to executing this command.
all
Sends GTP-C echo requests to first 100 peers that currently have sessions with the GGSN/P-GW service.
Important:
If this keyword is selected, additional confirmation is required after the following message,
“Warning: Due to possibility of huge number of connected peers, considering system performance impacts, issue echo
request to only 100 peers”.
request to only 100 peers”.