Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Configuration Mode Commands
fw-and-nat action ▀
Command Line Interface Reference, StarOS Release 18 ▄
495
fw-and-nat action
This command allows you to create/configure/delete Firewall-and-NAT actions.
Important:
This command is available only in 11.0 and later releases. This command must be used to configure
the Stateful Firewall and NAT Action.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
fw-and-nat action action_name [ -noconfirm ]
no fw-and-nat action action_name
no
If previously configured, deletes the specified Firewall-and-NAT action from the active charging service.
action_name
Specifies the Firewall-and-NAT action to add/configure/delete.
action_name
must be the name of a Firewall-and-NAT action, and must be an alphanumeric string of 1
through 63 characters. Each Firewall-and-NAT action must have a unique name.
-noconfirm
Specifies that the command must execute without prompting for confirmation.
Usage
Use this command to create/configure/delete a Firewall-and-NAT action.
On entering this command, the CLI prompt changes to:
On entering this command, the CLI prompt changes to:
[context_name]hostname(config-fw-and-nat-action)#
Also see the Firewall-and-NAT Action Configuration Mode Commands chapter.
Example
The following command creates a Firewall-and-NAT action named
test1
, and changes to the Firewall-and-
NAT Action Configuration Mode: