Cisco Cisco Packet Data Interworking Function (PDIF)
Firewall-and-NAT Access Ruledef Configuration Mode Commands
▀ udp either-port
▄ Command Line Interface Reference, StarOS Release 18
5186
udp either-port
This command configures an access ruledef to analyze user traffic based on either (destination or source) UDP port.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Access Ruledef Configuration
active-charging service service_name > access-ruledef access_ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-fw-ruledef)#
Syntax
[ no ] udp either-port { operator port_number | { !range | range } { start_range to
end_range | port-map port_map } }
end_range | port-map port_map } }
no
Removes previously configured either-port (destination or source) UDP ruledef.
operator
Specifies how to logically match the port number.
operator
must be one of the following:
!=
: Does not equal
<=
: Less than or equals
=
: Equals
>=
: Greater than or equals
port_number
Specifies the port number to match.
port_number
must be an integer from 1 through 65535.
!range | range
Specifies the range criteria.
!range
: Not in the range
range
: In the range
start_range to end_range
Specifies the starting and ending port numbers for the port range.
start_range
must be an integer from 1 through 65535.
end_range
must be an integer from 1 through 65535 that is greater than
start_range
.