Cisco Cisco Packet Data Interworking Function (PDIF)
GGSN Service Configuration Mode Commands
setup-timeout ▀
Command Line Interface Reference, StarOS Release 18 ▄
5273
setup-timeout
Configures the maximum amount of time the GGSN service allows for the setting up of PDP contexts.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
setup-timeout setup_time
default setup-timeout
default
Restores the command to its default setting of 60.
setup_time
Default: 60
Specifies the maximum amount of time the GGSN service allows for the setting up of PDP contexts.
Specifies the maximum amount of time the GGSN service allows for the setting up of PDP contexts.
setup_time
is measured in seconds and can be configured to an integer from 1 through 6000.
Usage
Use this command to limit the amount of time allowed for setting up PDP contexts. If the PDP context is not
setup within the configured time frame, the GGSN service rejects the PDP context with a cause code of 199
(C7H, No resources available).
setup within the configured time frame, the GGSN service rejects the PDP context with a cause code of 199
(C7H, No resources available).
Example
The following command allows a maximum of
120
seconds for the setting up of PDP contexts:
setup-timeout 120