Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (A-K)
▀ boot networkconfig
▄ Command Line Interface Reference, StarOS Release 18
5306
boot networkconfig
Configures the networking parameters for the Switch Processor I/O card network interfaces to use when obtaining a
software image from an external network server during the system boot process.
software image from an external network server during the system boot process.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
boot networkconfig { dhcp | { { dhcp-static-fallback | static } ip address spio24
ip_address [ spio25 ip_address ] netmask ip_mask [ gateway gw_address ] } }
ip_address [ spio25 ip_address ] netmask ip_mask [ gateway gw_address ] } }
no boot networkconfig
no
Removes the network configuration information from the boot.sys file.
dhcp
Indicates that a Dynamic Host Control Protocol (DHCP) server is used for communicating with the external
network server.
network server.
dhcp-static-fallback
|
static
dhcp-static-fallback
: provides static IP address fallback network option when a DHCP server is
unavailable.
static
: specifies a fixed network IP address for the external network server that hosts the software image.
spio24
ip_address
[
spio25
ip_address
]
netmask
ip_mask
[
gateway
gw_address
]
spio24
ip_address
[
spio25
ip_address
]: the IP address to use for the SPIO in slot 24 and optionally
the SPIO in slot 25 for network booting.
ip_address
must be specified using IPv4 dotted-decimal notation.
netmask
ip_mask
: the network mask to use in conjunction with the IP address(es) specified for network
booting.
ip_mask
must be specified using IPv4 dotted-decimal notation.
gateway
gw_address
: the IP address of a network gateway to use in conjunction with the IP address(es)
specified for network booting.
gw_address
must be entered using IPv4 dotted-decimal notation.
Important:
If
gw_address
is not specified, the network server must be on the same LAN as the system. Since
both SPIOs must be in the same network, the netmask and gateway settings are shared.