Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold per-service-gprs-pdp-sessions
▄ Command Line Interface Reference, StarOS Release 18
5726
threshold per-service-gprs-pdp-sessions
Configures alarm or alert thresholds for the number of 2G-activated PDP contexts per GPRS service.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold per-service-gprs-pdp-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of 2G-activated PDP contexts for any one GPRS service. This number
must be met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number of 2G-activated PDP contexts for any one GPRS service. This number
must be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 4000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of 2G-activated PDP contexts for any one GPRS service. This number or
higher maintains a previously generated alarm condition. If the number of sessions falls beneath the low
threshold within the polling interval, then a clear alarm will be generated.
Specifies the low threshold number of 2G-activated PDP contexts for any one GPRS service. This number or
higher maintains a previously generated alarm condition. If the number of sessions falls beneath the low
threshold within the polling interval, then a clear alarm will be generated.
low_thresh
is an integer from 0 through 4000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of 2G-activated PDP contexts for any GPRS service in the
system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
Enter condition: Actual number of PDP contexts for any GPRS service is greater than or equal to the
high threshold.
Clear condition: Actual number of PDP contexts is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.