Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll asngw-session-timeout interval ▀
Command Line Interface Reference, StarOS Release 18 ▄
5795
threshold poll asngw-session-timeout interval
Configures the polling interval over which to count or measure the thresholding value for session timeout.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll asngw-session-timeout interval dur
default threshold poll asngw-session-timeout interval
default
Restores the specified parameter to its default value (300 seconds).
interval
dur
Default: 300 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
dur
is an integer from 30 through 60000 in multiples of 30.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshASNGWSessTimeout
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the session timeout threshold:
threshold poll asngw-session-timeout interval 600