Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll dcca-protocol-error interval
▄ Command Line Interface Reference, StarOS Release 18
5826
threshold poll dcca-protocol-error interval
Configures the polling interval for Diameter Credit-Control Application (DCCA) Protocol Error threshold.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll dcca-protocol-error interval duration
default threshold poll dcca-protocol-error interval
default
Uses the default threshold polling interval.
Default: 900 seconds
Default: 900 seconds
interval duration
Specifies the polling interval (in seconds) for the DCCA Protocol Error threshold.
duration
must be an integer from 60 through 60000.
Usage
Use this the polling interval for DCCA Protocol Error threshold.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholding in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshDCCAProtocolError
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the DCCA protocol error
threshold:
threshold poll dcca-protocol-error interval 600