Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll error-reg-auth interval ▀
Command Line Interface Reference, StarOS Release 18 ▄
5837
threshold poll error-reg-auth interval
Configures the polling interval in seconds over which to count CSCF Reg-Auth Errors.
Product
SCM
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll error-reg-auth interval duration
interval duration
Default: 300 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 60 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshCSCFSvcErrorRegAuth
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the CSCF Reg-Auth Errors
threshold:
threshold poll error-reg-auth interval 600