Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll henbgw-paging-messages interval
▄ Command Line Interface Reference, StarOS Release 18
5848
threshold poll henbgw-paging-messages interval
Configures how frequently the HeNB-GW paging messages are polled.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll henbgw-paging-messages interval duration
interval duration
Default: 0 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 30 through 60000.
Usage
This command configures how frequently the HeNB-GW paging messages are polled.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshHeNBGWPagingMessages
command in this mode.
Example
The following command configures the polling interval to
6000
seconds for the HeNB-GW service:
threshold poll henbgw-paging-messages interval 6000