Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands O - Z)
threshold poll phspc-session-setup-timeout interval ▀
Command Line Interface Reference, StarOS Release 18 ▄
5897
threshold poll phspc-session-setup-timeout interval
Configures the polling interval in seconds over which to count the number of Personal Handyphone System - Personal
Computer (PHSPC) sessions that timed out during setup.
Computer (PHSPC) sessions that timed out during setup.
Product
PHSGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll phspc-session-setup-timeout interval duration
interval duration
Default: 0 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 30 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPHSPCSessSetupTimeout
command in this mode.
Example
The following command configures the polling interval to
600
seconds for PHSPC session setup timeouts:
threshold poll phspc-session-setup-timeout interval 600