Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands O - Z)
▀ threshold poll port-rx-utilization interval
▄ Command Line Interface Reference, StarOS Release 18
5902
threshold poll port-rx-utilization interval
Configures the polling interval in seconds over which to measure the overall percentage of incoming traffic received
over system ports.
over system ports.
Product
All
Privilege
Administrator Security Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll port-rx-utilization interval seconds
interval seconds
Configures the threshold polling interval in multiples of 30 seconds.
seconds
is an integer from 30 to 60000.
Default is 300 seconds.
Usage
Receive port utilization thresholds generate alerts or alarms based on the utilization percentage of each
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis configured using the port
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis configured using the port
port-type
slot#/port#
command syntax.
Important:
This command is not available on all platforms
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
(The transmitted and received percentages are combined.) Therefore, to avoid redundant alarms, it is recommended that
only the receive or transmit utilization threshold be configured.
only the receive or transmit utilization threshold be configured.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPortRxUtil
command in this mode.
Example
Use the following example to configure a threshold poll interval of
300
seconds (5 minutes)
threshold poll port-rx-utilization interval 300