Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands O - Z)
▀ threshold poll total-asngw-sessions interval
▄ Command Line Interface Reference, StarOS Release 18
5914
threshold poll total-asngw-sessions interval
Configures the polling interval over which to count or measure the thresholding value for the total number of sessions
across all the ASN-GW services on a system to trigger an alert or alarm.
across all the ASN-GW services on a system to trigger an alert or alarm.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll total-asngw-sessions interval time
default threshold poll total-asngw-sessions interval
default
Restores the threshold polling interval value to its default value of 300 seconds.
interval
time
Default: 300 seconds
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
time
must be an integer from 30 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold model
and
threshold monitoring
commands for additional information on the
system’s support for thresholding.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshASNGWSessions
command in this mode.
Example
The following command configures the polling interval for counting the total number of ASN-GW sessions
across all the ASN-GW services on a system, to
across all the ASN-GW services on a system, to
600
seconds (10 minutes):