Cisco Cisco Packet Data Interworking Function (PDIF)
GTPC Load Control Profile Configuration Mode Commands
▀ inclusion-frequency
▄ Command Line Interface Reference, StarOS Release 18
6124
inclusion-frequency
Configures parameters to determine the inclusion frequency of the Load Control Information IE for a GTP-C Load
Control Profile configuration.
Control Profile configuration.
Important:
GTP-C Load Control Profile is a license-controlled feature. For more information, contact your
Cisco account or support representative.
Product
P-GW
SAEGW
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration > GTPC Load Control Profile Configuration
configure > gtpc-load-control-profile
profile_name
Entering the above command results in the following prompt:
[local]host_name(config-gtpc-load-control-profile)#
Syntax
inclusion-frequency { advertisement-interval interval_in_seconds | change-factor
change_factor }
change_factor }
default inclusion-frequency { advertisement-interval | change-factor }
inclusion-frequency
Specifies that parameters to determine the inclusion frequency of the Load Control Information IE for a GTP-
C Load Control Profile configuration will be configured. The Load Control Information IE is a 3GPP-specific
IE that is sent to peers when a configured threshold is reached. This parameter specifies how often the
operator wants to send this information to the peers.
C Load Control Profile configuration will be configured. The Load Control Information IE is a 3GPP-specific
IE that is sent to peers when a configured threshold is reached. This parameter specifies how often the
operator wants to send this information to the peers.
advertisement-interval interval_in_seconds
Configures the advertisement-interval for Load Control in seconds. Specifies how often load control
information should be sent to the peers. If configured to 0, the node will send load control information in each
and every outgoing message to the peers.
information should be sent to the peers. If configured to 0, the node will send load control information in each
and every outgoing message to the peers.
interval_in_seconds
must be an integer from 0 to 3600.
Default: 300
change-factor change_factor
Configures the change factor for Load Control. If the load control factor changes by the configured factor,
whether it is an increase or decrease, the load control information should be sent to the peers. This
information is only sent to the peers when the load factor changes by the factor configured.
whether it is an increase or decrease, the load control information should be sent to the peers. This
information is only sent to the peers when the load factor changes by the factor configured.