Cisco Cisco Packet Data Interworking Function (PDIF)
GTPC Overload Control Profile Configuration Mode Commands
▀ inclusion-frequency
▄ Command Line Interface Reference, StarOS Release 18
6134
inclusion-frequency
Configure parameters to determine the inclusion frequency of the Overload Control Information IE.
Important:
GTP-C Overload Control Profile is a license-controlled feature. For more information, contact your
Cisco account or support representative.
Product
P-GW
SAEGW
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration > GTPC Overload Control Profile Configuration
configure > gtpc-overload-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-gtpc-overload-control-profile)#
Syntax
inclusion-frequency { advertisement-interval interval_in_seconds | change-factor
change_factor }
change_factor }
default inclusion-frequency { advertisement-interval | change-factor }
inclusion-frequency
Specifies that parameters to determine the inclusion frequency of the Overload Control Information IE for a
GTP-C Overload Control Profile configuration will be configured. The Overload Control Information IE is a
3GPP-specific IE that is sent to peers when a configured threshold is reached. This parameter specifies how
often the operator wants to send overload information to the peers.
GTP-C Overload Control Profile configuration will be configured. The Overload Control Information IE is a
3GPP-specific IE that is sent to peers when a configured threshold is reached. This parameter specifies how
often the operator wants to send overload information to the peers.
advertisement-interval interval_in_seconds
Configures the advertisement-interval for overload control in seconds. Specifies how often overload control
information should be sent to the peers. If configured to 0, the node will send overload control information in
each and every outgoing message to the peers.
information should be sent to the peers. If configured to 0, the node will send overload control information in
each and every outgoing message to the peers.
interval_in_seconds
must be an integer from 0 to 3600.
Default: 300
change-factor change_factor
P-GW only. Configures the change factor for overload control. If the overload control factor changes by a
configured factor, whether by an increase or decrease, the overload control information should be sent to the
peers. This information is only sent to the peers when the overload factor changes by the factor configured.
configured factor, whether by an increase or decrease, the overload control information should be sent to the
peers. This information is only sent to the peers when the overload factor changes by the factor configured.
change_factor
must be an integer from 1 to 20.