Cisco Cisco Packet Data Interworking Function (PDIF)
HA Service Configuration Mode Commands
bind ▀
Command Line Interface Reference, StarOS Release 18 ▄
6249
bind
Binds the HA service to a logical IP interface serving as the Pi interface and specifies the maximum number of
subscribers that can access this service over the interface.
subscribers that can access this service over the interface.
Product
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ha-service)#
Syntax
bind address { range_IPv4address ip_mask | range_IPv4address/bitmask } [ max-subscribers
count ]
count ]
no bind address
range_IPv4address ip_mask | range_IPv4address/bitmask
Specifies the pool of IP addresses (in IPv4 dotted-decimal notation) of the interface configured as the Pi
interface with an enterprise HA (EHA).
interface with an enterprise HA (EHA).
ip_mask
and
bitmask
specifies the number of subnet bits,
representing the subnet mask in CIDR notation and must be a value between 1 to 32.
range_IPv4address
is a preconfigured range of IPv4 addresses in Loopback Interface Configuration Mode
to enable the Enterprise HA support with enhanced capacity and configured
max-subscribers
count
Default:
2500000
Specifies the maximum number of subscribers that can access this service on this interface.
count
can be configured to an integer from 0 through 4000000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active packet processing cards installed in the system.
Usage
Associate the HA service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of a Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
characteristics of a Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
max-subscribers
option, be sure to consider the following:
The total number of interfaces that you will configuring for use as Pi interfaces