Cisco Cisco Packet Data Interworking Function (PDIF)
HeNB-GW Access Service Configuration Mode Commands
bind s1-mme ▀
Command Line Interface Reference, StarOS Release 18 ▄
6315
bind s1-mme
Binds the pre configured HeNB-GW Access Service to the IP address of the S1-MME interface.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HeNBGW-Access Service Configuration
configure > context context_name > henbgw-access-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-henbgw-access-service)#
Syntax
bind s1-mme { ipv4-address | ipv6-address } ip_addr max-subscribers max_sub
no bind s1-mme
no
Removes the binding of S1-MME interface from this HeNB-GW Access service configuration.
ip_addr
Identifies the IP address of the S1-MME interface to associate with this HeNB-GW Access service.
addr_val
must be entered in the IPv4 ( dotted decimal notation) or IPv6 (: / :: notation) .
max-subscribers max_sub
Configures the maximum number of subscribers HENBGW ACCESS service can support.
max_sub
is an integer ranging from
0
through
4000000
.
Usage
Use this command to bind the pre configured IPv4 address of the S1-MME interface to the HeNB-GW
Access Service.
Access Service.
Example
Following command binds the S1-MME interface having
192.68.111.61
IP address with specific HeNB-
GW Access service.
bind s1-mme ipv4-address 192.68.111.61 max-subscribers 20