Cisco Cisco Packet Data Interworking Function (PDIF)
HeNB-GW Access Service Configuration Mode Commands
mme-id ▀
Command Line Interface Reference, StarOS Release 18 ▄
6319
mme-id
Configures the MME ID for this HeNB-GW Access service. For this configuration, MME Group ID and MME Code
has to be configured.
has to be configured.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HeNBGW-Access Service Configuration
configure > context context_name > henbgw-access-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-henbgw-access-service)#
Syntax
mme-id group-id mme_group_id mme-code mme_code
no mme-id
no
Removes the configured MME ID from this HeNB-GW Access service configuration.
mme_group_id
Identifies the MME Group ID which must be entered as an integer between 32768 and 65535.
mme_code
Identifies the MME code which is again an integer value between 0 and 255.
Usage
Use this command to configure the MME Identifier which includes the MME Group ID and MME Code for
this HeNB-GW Access service. MME ID configuration is required, because it is the same ID which HeNB-
GW sends in response messages to HeNBs.
this HeNB-GW Access service. MME ID configuration is required, because it is the same ID which HeNB-
GW sends in response messages to HeNBs.
Caution:
Changing the MME ID is a disruptive operation. HeNB-GW service is restarted on any change.
Example
Following command configures 32770 as the MME Group ID and 105 as MME code on a specific HeNB-
GW Access service.
GW Access service.
mme-id group-id 32770 mme-code 105