Cisco Cisco Packet Data Interworking Function (PDIF)
HSGW Service Configuration Mode Commands
policy overload ▀
Command Line Interface Reference, StarOS Release 18 ▄
6369
policy overload
Specifies how an HSGW service should handle overload conditions.
Product
HSGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-hsgw-service)#
Syntax
policy overload { redirect address [ weight weight_num ] [ address2 [ weight weight_num ]
... address16 [ weight weight_num ] ] | reject [ use reject-code { admin-prohibite |
insufficient-resources } ] }
... address16 [ weight weight_num ] ] | reject [ use reject-code { admin-prohibite |
insufficient-resources } ] }
default policy overload
no policy overload [ redirect address [ address2 ] ... [ address16 ]
default
Returns the command to it default setting of “reject” with the “admin-prohibited” code.
no
Removes a specified “redirect address” from this service.
redirect address [ weight weight_num ] [ address2 [ weight weight_num ] ...
address16 [ weight weight_num ] ]
address16 [ weight weight_num ] ]
This option enables a redirect policy for overloading conditions. When a redirect policy is invoked, the
HSGW service rejects new sessions with an A11 Registration Reply Code of 88H (unknown HSGW address)
and provides the IP address of an alternate HSGW. This command can be issued multiple times.
HSGW service rejects new sessions with an A11 Registration Reply Code of 88H (unknown HSGW address)
and provides the IP address of an alternate HSGW. This command can be issued multiple times.
address
: The IP address of an alternate HSGW expressed in IPv4 dotted decimal notation. Up to 16 IP
addresses can be specified either in one command or by issuing the redirect command multiple times. If you
try to add more than 16 IP addresses to the redirect policy the CLI issues an error message. If you specify an
IP address and weight that already exists in the redirect policy the new values override the existing values.
try to add more than 16 IP addresses to the redirect policy the CLI issues an error message. If you specify an
IP address and weight that already exists in the redirect policy the new values override the existing values.
weight
weight_num
: When multiple addresses are specified, they are selected in a weighted round-robin
scheme. Entries with higher weights are more likely to be chosen. If a weight is not specified, the entry is
automatically assigned a weight of 1 (default).
automatically assigned a weight of 1 (default).
weight_num
must be an integer value from 1 through 10.
reject [ use reject-code { admin-prohibite | insufficient-resources } ]
This option will cause any overload traffic to be rejected. The HSGW sends an A11 Registration Reply Code
of 82H (insufficient resources).
of 82H (insufficient resources).