Cisco Cisco Packet Data Interworking Function (PDIF)
HNB-GW Service Configuration Mode Commands
▀ sctp bind
▄ Command Line Interface Reference, StarOS Release 18
6486
sctp bind
Configures the SCTP IP address and port that is used for binding the SCTP socket to communicate with the Home-
NodeB over an Iuh interface within an HNB-GW service.
NodeB over an Iuh interface within an HNB-GW service.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnbgw-service)#
Syntax
sctp bind { address IPv4_address | port port_num }
no sctp bind { address | port }
no
Removes the SCTP binding.
address
IPv4_address
Specifies the IP address of the HNB-GW Iuh interface in IPv4 dotted-decimal.
port port_num
Specifies the SCTP port number to communicate with the Home-NodeBs using Iuh interface as an integer
form 1 through 65535.
form 1 through 65535.
Usage
Use this command to assign the SCTP IP address and port with SCTP socket on HNB-GW to communicate
with the Home-NodeB using Iuh interface. This SCTP configuration provides the IP-address and listen port
where HNB-GW service shall bind to listen for incoming SCTP associations from HNB.
with the Home-NodeB using Iuh interface. This SCTP configuration provides the IP-address and listen port
where HNB-GW service shall bind to listen for incoming SCTP associations from HNB.
Example
The following command sets the SCTP port number
999
on HNB-GW to listen from Home-NodeB over Iuh
interface:
sctp bind port 999
The following command sets the SCTP address
10.2.3.4
of HNB-GW to use with Home-NodeB over Iuh
interface:
sctp bind address 10.2.3.4