Cisco Cisco Packet Data Interworking Function (PDIF)
HNB-GW Service Configuration Mode Commands
▀ security-gateway bind
▄ Command Line Interface Reference, StarOS Release 18
6496
security-gateway bind
Binds the SeGW in an HNB-GW service to a logical IP interface serving as an Iuh interface and associates an IPsec
IKEv2 crypto-map template.
IKEv2 crypto-map template.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnbgw-service)#
Syntax
security-gateway bind address IPv4_address crypto-template cryp_name [ context ctxt_name]
no security-gateway bind
no
Removes a previously configured IPSec IP address use for binding the IKEv2 IPSec tunnel (local bind
address) to communicate with the Home-NodeBs using Iuh interface.
address) to communicate with the Home-NodeBs using Iuh interface.
bind address
IPv4_address
Specifies the IP address for the Iuh interface for the IPSec tunnel. This is the IP address where the HNB-GW
service is bound and that is provided to the Home-NodeB during HNB-GW discovery.
The IP address is expressed in IPv4 dotted-decimal.
service is bound and that is provided to the Home-NodeB during HNB-GW discovery.
The IP address is expressed in IPv4 dotted-decimal.
crypto-template
cryp_name
Specifies the Crypto-map template to be used for IPsec IKEv2 tunneling for the interface configured as an
Iuh.
Iuh.
cryp_name
specifies the name of the pre-configured Crypto-map template which is configured in Crypto-
Map Template Configuration mode and associated with the HNB-GW service to create an IPSec tunnel with
a Home-NodeB during HNB-GW discovery procedure over an Iuh interface.
a Home-NodeB during HNB-GW discovery procedure over an Iuh interface.
context
ctx_name
Specifies the name of the pre-configured context in which the Security Gateway service is configured. By
default this command uses the HNB-GW service context for the security Gateway configuration.
default this command uses the HNB-GW service context for the security Gateway configuration.
Usage
Use this command to associate or tie the HNB-GW service to a specific logical IP address that is used for
binding the Iuh socket to communicate with the Home-NodeB using IPSec tunnel. A maximum of one IP
address can be configured with this command for one HNB-GW service.
binding the Iuh socket to communicate with the Home-NodeB using IPSec tunnel. A maximum of one IP
address can be configured with this command for one HNB-GW service.