Cisco Cisco Packet Data Interworking Function (PDIF)
IPv6 to IPv4 Tunnel Interface Configuration Mode Commands
mode ▀
Command Line Interface Reference, StarOS Release 18 ▄
6831
mode
Configures the mode of IPv6 to IPv4 tunneling. The default is set to manual mode.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Tunnel Interface Configuration > IPv6 to IPv4 Tunnel Interface
Configuration
Configuration
configure > context context_name > interface interface_name tunnel > tunnel-mode ipv6ip
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-tunnel-ipv6ip)#
Syntax
mode { 6to4 | manual }
default mode
6to4
Configures automatic IPv6-to-IPv4 (6to4) tunnels as specified in RFC 3056.
manual
Configures point-to-point manual IPv6-to-IPv4 tunnels by specifying the IPv4 address of the tunnel remote
end.
end.
default
Resets the mode of IPv6-to-IPv4 tunneling to manual mode.
Usage
There can be only one IPv6-to-IPv4 tunnel possible in a context. Once an IPv6-to-IPv4 tunnel is configured,
all subsequent tunnels will be configured as manual tunnels.
all subsequent tunnels will be configured as manual tunnels.
Example
The following command configures the mode to IPv6-to-IPv4 (
6to4
).
mode 6to4
The following command configures the mode to
6to4
.
mode manual