Cisco Cisco Packet Data Interworking Function (PDIF)
LNS Service Configuration Mode Commands
▀ default
▄ Command Line Interface Reference, StarOS Release 18
6992
default
This command sets the specified LAC service parameter to its default value or setting.
Product
PDSN
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > LNS Service Configuration
configure > context context_name > lns-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-lns-service)#
Syntax
default { authentication | data sequence-number | ip source-violation | keepalive-
interval | load-balancing | local-receive-window | max-retransmission | max-session-per-
tunnel | max-tunnel-challenge-length | max-tunnels | proxy-lcp-authentication |
retransmission-timeout-first | retransmission-timeout-max | setup-timeout| single-port-
mode | subscriber| trap all tunnel-authentication}
interval | load-balancing | local-receive-window | max-retransmission | max-session-per-
tunnel | max-tunnel-challenge-length | max-tunnels | proxy-lcp-authentication |
retransmission-timeout-first | retransmission-timeout-max | setup-timeout| single-port-
mode | subscriber| trap all tunnel-authentication}
authentication
Sets the authentication parameters for PPP sessions to the following defaults:
allow-noauth disabled
chap enabled with a priority of 1
mschap disabled
msid-auth disabled
pap enabled with a priority of 2
data sequence-number
Enables data sequence numbering for sessions.
ip source-violation
Sets the IP source violation parameters to the following defaults:
drop-limit 10
period 120 seconds
reneg-limit 5
keepalive-interval
Sets the interval for send L2TP Hello keepalive if there is no control or data transactions to the default value
of 60 seconds.
of 60 seconds.