Cisco Cisco Packet Data Interworking Function (PDIF)
MME Service Configuration Mode Commands
policy idle-mode ▀
Command Line Interface Reference, StarOS Release 18 ▄
7387
policy idle-mode
Configures the user-defined behavioral policies of session management for an LTE subscriber in an MME service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
policy idle-mode detach { explicit | implicit }
default policy idle-mode detach
default
Sets the policy configuration to the default behavior for subscriber IDLE mode Detach. The default behavior
is Detach implicit.
is Detach implicit.
idle-mode detach
Configures the IDLE mode Detach behavior of a UE.
detach
Defines the Detach procedure while the UE is in IDLE mode.
explicit
Enables the Explicit Detach while a UE is in IDLE mode. The system will page the UE before Detach
procedure is started, and then perform the Explicit Detach procedure.
procedure is started, and then perform the Explicit Detach procedure.
implicit
Enables the Implicit Detach while a UE is in IDLE mode. The system never sends any message to the UE
before Detach, and executes the Implicit Detach procedure immediately. This is the default behavior.
before Detach, and executes the Implicit Detach procedure immediately. This is the default behavior.
Usage
Use this command to set the user-defined policies for session management in this MME service.
Example
The following command sets the Idle Mode Detach policy to Implicit for a user in this MME service:
policy idle-mode detach implicit