Cisco Cisco Packet Data Interworking Function (PDIF)
MME Service Configuration Mode Commands
▀ ps-lte
▄ Command Line Interface Reference, StarOS Release 18
7406
ps-lte
Configures the Public Safety LTE (PS-LTE) mode of operation for this MME service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
ps-lte sgw { ipv4_address | ipv6_address }
no ps-lte
no
Disables PS-LTE mode of operation.
sgw { ipv4_address | ipv6_address }
Configures the IP address of the S11 interface of the S-GW to use for PS-LTE mode of operation.
ip_address
specifies the IP address for the S-GW in IPv4 dotted-decimal or IPv6 colon-separated notation.
Usage
This feature requires that a valid license key be installed. Contact your Cisco Account or Support
representative for information on how to obtain a license.
Use this command to enable the MME service for use in a Public Safety LTE (PS-LTE) network. In this
mode, the MME is co-located with an S-GW and at least one P-GW, and the MME must always use the co-
located S-GW and a co-located P-GW for all calls that it handles. This requires configuring the IP addresses
of the S11 interface of the S-GW as part of the MME service configuration.
Configuration of the S5/S8 interface to the P-GW must be configured separately as part of an APN profile
configuration (refer to the
representative for information on how to obtain a license.
Use this command to enable the MME service for use in a Public Safety LTE (PS-LTE) network. In this
mode, the MME is co-located with an S-GW and at least one P-GW, and the MME must always use the co-
located S-GW and a co-located P-GW for all calls that it handles. This requires configuring the IP addresses
of the S11 interface of the S-GW as part of the MME service configuration.
Configuration of the S5/S8 interface to the P-GW must be configured separately as part of an APN profile
configuration (refer to the
pgw-address
command within the APN Profile Configuration Mode chapter in
the Command Line Interface Reference).
When enabled, all other S-GW selection mechanisms are overridden. The MME will only use the S-GW
configured for PS-LTE operation and the P-GW configured in the matching APN profile, regardless of any
other configuration present.
When enabled, all other S-GW selection mechanisms are overridden. The MME will only use the S-GW
configured for PS-LTE operation and the P-GW configured in the matching APN profile, regardless of any
other configuration present.
Example
The following command enables PS-LTE mode for this MME service and configures the IP address of the
S11 interface for the S-GW as 192.60.60.7.
S11 interface for the S-GW as 192.60.60.7.
ps-lte sgw 192.60.60.7