Cisco Cisco Packet Data Interworking Function (PDIF)
MPLS-LDP Configuration Mode Commands
▀ discovery
▄ Command Line Interface Reference, StarOS Release 18
7442
discovery
Configures the Label Distribution Protocol (LDP) neighbor discovery parameters.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MPLS-IP Configuration > MPLS-LDP Configuration
configure > context context_name > mpls-ip > protocol ldp
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ldp)#
Syntax
discovery { hello { hello-interval integer_value | hold-interval integer_value } |
transport-address ipv4_addr }
transport-address ipv4_addr }
default discovery hello
no discovery transport-address
default
Sets the LDP discovery hello interval at 5 seconds and hold interval at 15 seconds.
no
Disables the LDP neighbor discovery.
hello { hello-interval integer_value | hold-interval integer_value }
Configures the LDP Hello parameters.
hello-interval
configures the frequency of sending the Discovery Hello packets in seconds.
integer_value
is an integer from 5 through 21845.
Default: 5
hold-interval
configures the Discovery Hold time interval in seconds.
integer_value
is an integer from 15 through 65535.
Default: 15
transport-address
ipv4_addr
Configures the LDP transport address as an IPv4 address entered in dotted-decimal notation. Transport
address is the same as the LDP router ID.
address is the same as the LDP router ID.