Cisco Cisco Packet Data Interworking Function (PDIF)
ORBEM Configuration Mode Commands
event-notif-service ▀
Command Line Interface Reference, StarOS Release 18 ▄
7525
event-notif-service
Enables or disables the ORB Notification Service and allows the configuration of filters dictating which event
notifications are sent.
notifications are sent.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > ORBEM Configuration
configure > orbem
Entering the above command sequence results in the following prompt:
[local]host_name(config-orbem)#
Syntax
[ no ] event-notif-service [ filter { event-id event_id [ to final_event_id ] | facility
event_facility level event_level } ]
event_facility level event_level } ]
default event-notif-service filter
default
Restores the ORB Notification Service filter to its default behavior of sending all “error” level and higher
events, and “info” level events for the orbs facility, CLI command logs, and license change logs.
events, and “info” level events for the orbs facility, CLI command logs, and license change logs.
no
Disables the event notification service.
filter
Specifies a filter that determines for which events the system sends notifications.
event-id
event_id
[ to
final_event_id
]
Specifies an event filter based on event identification (event ID) number.
event_id
is a specific event ID to filter or is the initial event ID in range if the
to
keyword is used.
In 14.1 and earlier releases,
event_id
is an integer from 1 through 202699.
In 15.0 and later releases,
event_id
is an integer from 1 through 204999.
to
allows the specification of a range of event IDs to filter. When used,
final_event_id
specifies the last
event ID in the range to be filtered. It can be configured to an integer from 1 through 204999, but must be a
value greater than the initial event ID.
value greater than the initial event ID.
facility
event_facility
level
event_level
Specifies an event filter based on facility type and notification severity level.
event_facility
specifies the facility type and can be any one of the following:
a10: A10 interface facility
a11: A11 interface facility