Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-AF-Service Configuration Mode Commands
▀ diameter origin end-point
▄ Command Line Interface Reference, StarOS Release 18
7672
diameter origin end-point
This command is used to bind/associate a pre-configured Diameter host/realm (AF) over Rx interface with a PCC-AF-
Service to be used for subscriber service control and AF profile management.
Service to be used for subscriber service control and AF profile management.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC AF Service Configuration
configure > context context_name > pcc-af-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-imsapp-service)#
Syntax
diameter origin endpoint dia_endpoint_name
no diameter origin endpoint
no
Removes the associated Diameter Origin Endpoint configuration from PCC-AF-Service instance configured
for IPCF configuration.
for IPCF configuration.
any
Sets the PCC-AF-Service instance to use any available AF node over Rx interface for AF support.
dia_endpoint_name
The
dia_endpoint_name
is a predefined Diameter origin endpoint node and must be an alphanumerical
string from 1 through 63 characters.
Usage
Use this command to bind the AF node over Rx interface by associating a pre-configured Diameter Origin
Endpoint with a PCC-AF-Service.
The Diameter origin endpoint must be a pre-configured instance in the Context Configuration Mode. For
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
Endpoint with a PCC-AF-Service.
The Diameter origin endpoint must be a pre-configured instance in the Context Configuration Mode. For
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
Example
Following command associates a pre-configured Diameter endpoint node configuration named
af_pcscf1
with a PCC-AF-Service for AF profile management.
diameter origin endpoint af_pcscf1
Following command removes the pre-associated Diameter endpoint node configuration named
af_pcscf1
with a PCC-AF-Service.