Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-Condition-Group Configuration Mode Commands
radio-access-technology ▀
Command Line Interface Reference, StarOS Release 18 ▄
7719
radio-access-technology
This command defines a condition based on the radio access technology used by subscriber in an IP-CAN session.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Condition Group
Configuration
Configuration
configure > context context_name > pcc-service service_name > condition group group_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-condition-group)#
Syntax
[ no ] radio-access-technology operator value RAT
[ no ] radio-access-technology operator profile-attribute spr_attr_value
[ no ] radio-access-technology operator subscription-attribute subs_prof_attr_value
no
Removes the specified condition definition.
operator
Specifies how to logically match the media type in user traffic.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
RAT
Specifies the radio access technology used by subscriber to access the network as condition definition for user
traffic in an IP-CAN session.
Following RAT are supported with this command:
traffic in an IP-CAN session.
Following RAT are supported with this command:
cdma2000-1x
: 3GPP2 CDMA 2000 - 1x RTT
eutran
: Evolved Universal Terrestrial Radio Access Network (eUTRAN)
gan
: Generic Access Network (GAN)
geran
: GSM Edge Radio Access Network (GERAN)
hrpd
: High Rate Packet Data (CDMA 2000 1xEV-DO)
hspa-evolution
: Evolved High-Speed Packet Access (eHSPA/HSPA+)
umb
: Ultra-Mobile Broadband