Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-Data-Service Configuration Mode Commands
▀ flow direction out
▄ Command Line Interface Reference, StarOS Release 18
7754
flow direction out
This command configures the flow service parameters for outgoing data flow in PCC-Data-Service instance.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Data Service Configuration
configure > context context_name > pcc-service service_name > data-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-data-service)#
Syntax
[no] flow direction in protocol {ip | tcp | udp} from {src_ip_addr
[ /
maskbit
]
| any} port
{src_port_num | any} to {dest_ip_addr
[ /
maskbit
]
| any} port {dest_port_num | any}
no
Removes the configured data service flow parameters from PCC-Data-Service instance on IPCF node.
protocol
{
ip
|
tcp
|
udp
}
This keyword configures the data flow parameters for specific protocol.
Following protocols are supported through this keyword:
Following protocols are supported through this keyword:
ip
: Sets the parameters for IP traffic.
tcp
: Sets the parameters for TCP traffic.
UDP
: Sets the parameters for UDP traffic.
from
{
src_ip_addr
|
any
}
port
{
src_port_num
|
any
}
This keyword configures the data flow condition parameters for specific protocol through IP address and port
as source of flow.
Following parameters are defined with this keyword:
as source of flow.
Following parameters are defined with this keyword:
src_ip_addr
: specifies the specific IP address in IPv4/IPv6 notation as source of flow.
maskbit
: Specifies the IP address suffix in IPv4 or IPv6 notation.
any
: specifies that flow from any source IP address/port can be analyzed or considered.
port
src_port_num
: specifies the specific source port parameter for flow.
src_port_num
is the source port number of flow and must be an integer from 1 through 65535.
to
{
dest_ip_addr
|
any
}
port
{
dest_port_num
|
any
}
This keyword configures the data flow condition parameters for specific protocol through IP address and port
as source of flow.
as source of flow.