Cisco Cisco Packet Data Interworking Function (PDIF)
PCP Configuration Mode Commands
server ▀
Command Line Interface Reference, StarOS Release 18 ▄
7885
server
Configures the IP address of the PCP server to receive PCP packets.
Important:
This command is customer specific. For more information, contact your Cisco account
representative.
Product
ACS
NAT
PSF
Privilege
Security Administrator, Administrator
Exec > ACS Configuration > Port Control Protocol Service Configuration
active-charging service service_name > pcp-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-pcp-service)#
Syntax
server ipv4-address ipv4_address [ port port_number ]
no server ipv4-address
server ipv4_address
Specifies the IPv4 address of the server to receive PCP packets.
ipv4_address
must be specified using the IPv4 dotted-decimal notation.
port port_number
Specifies the UDP port number where PCP Request messages are received by the PCP service.
port_number
must be an integer from 1 through 65535.
Default: 5351
Usage
Use this command to configure the IPv4 address on which the PCP service will receive PCP packets and the
port on which PCP Request messages will be received from the PCP service.
port on which PCP Request messages will be received from the PCP service.
Example
The following command configures the IPv4 address
1.2.3.4
with port number
5351
for the PCP service:
server ipv4-address 1.2.3.4 port 5351