Cisco Cisco Packet Data Interworking Function (PDIF)
P-GW Service Configuration Mode Commands
map-initial-setup-auth-fail-to-gtp-cause-user-auth-fail ▀
Command Line Interface Reference, StarOS Release 18 ▄
8067
map-initial-setup-auth-fail-to-gtp-cause-user-auth-fail
Maps Gx cause code (5xxx) to access side GTP cause code Auth-failure(92) in Create Session Response message.
Product
P-GW
SAEGW
Privilege
P-GW
SAEGW
Mode
Exec > Global Configuration > Context Configuration > P-GW Service Configuration
configure > context context_name > pgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pgw-service)#
Syntax
[ default | no ] map-initial-setup-auth-fail-to-gtp-cause-user-auth-fail
default
Maps Gx cause code (5xxx) to access side GTP cause code No-Resource(73) in Create Session Response
message.
message.
no
Maps Gx cause code (5xxx) to access side GTP cause code No-Resource(73) in Create Session Response
message.
message.
Usage
When Create Session Request message arrives at P-GW, CCR-I is sent to PCRF and PCRF rejects calls with
5xxx cause code in CCA-I. In this case, Create Session Response is sent with failure indicated by GTP cause
code. Use this command to control which GTP cause code is sent, “No Resources Available” or “User
Authentication Failed”, in Create Session Response message for this scenario. By default, “No Resources
Available” is sent for this case; however, enabling this command sends “User Authentication Failed” cause
code in Create Session Response.
5xxx cause code in CCA-I. In this case, Create Session Response is sent with failure indicated by GTP cause
code. Use this command to control which GTP cause code is sent, “No Resources Available” or “User
Authentication Failed”, in Create Session Response message for this scenario. By default, “No Resources
Available” is sent for this case; however, enabling this command sends “User Authentication Failed” cause
code in Create Session Response.
Example
The following command maps Gx cause code (5xxx) to access side GTP cause code Auth-failure(92) in
Create Session Response message..
Create Session Response message..
map-initial-setup-auth-fail-to-gtp-cause-user-auth-fail