Cisco Cisco Packet Data Interworking Function (PDIF)
Service Redundancy Protocol Configuration Mode Commands
monitor bgp ▀
Command Line Interface Reference, StarOS Release 18 ▄
8489
monitor bgp
Enables SRP monitoring of the connection between the specified Border Gateway Protocol (BGP) peer and the primary
chassis.
chassis.
Product
All products supporting ICSR
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
[ no ] monitor bgp context context_name { ipv4_address | ipv6_address } [ group group_id
[ vrf vrf_name ]
[ vrf vrf_name ]
no
Disables monitoring.
context
context_name
Identifies the context being used.
context_name
must be an existing context expressed as an alphanumeric
string of 1 through 79 characters.
ipv4 _address
|
ipv6_address
Specifies the IP address of the BGP peer to be monitored in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation.
hexadecimal notation.
group
group_id
Defines a Service Redundancy Protocol (SRP) peer group as an integer from 0 through 9. Default = 0.
In an Interchassis Session Recovery (ICSR) configuration, failover would occur if all peers within a group
fail (instead of all BGP peers in a context). This option is useful in deployments in which a combination of
IPv4 and IPv6 peers are spread across multiple paired VLANs and IPv4 or IPv6 connectivity is lost by all
members of a peer group.
In an Interchassis Session Recovery (ICSR) configuration, failover would occur if all peers within a group
fail (instead of all BGP peers in a context). This option is useful in deployments in which a combination of
IPv4 and IPv6 peers are spread across multiple paired VLANs and IPv4 or IPv6 connectivity is lost by all
members of a peer group.
vrf
vrf_name
Defines the VPN Routing/Forwarding instance as an alphanumeric string of 1 through 63 characters.
Usage
This command initiates monitoring of the connection between the primary chassis and the specified BGP peer
in the specified context. If the connection drops, the standby chassis becomes active.
in the specified context. If the connection drops, the standby chassis becomes active.
Example