Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
ftp client-port ▀
Command Line Interface Reference, StarOS Release 18 ▄
853
ftp client-port
This command allows you to define rule expressions to match port number of the FTP client.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] ftp client-port operator port_number
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
port_number
Specifies the client port number to match.
port_number
must be an integer from 1 through 65535.
Usage
Use this command to define rule expressions to match port number of the FTP client, which will be either the
TCP source port or the TCP destination port, depending on the direction.
TCP source port or the TCP destination port, depending on the direction.
Example
The following command defines a rule expression to match FTP client port number
10
:
ftp client-port = 10