Cisco Cisco Packet Data Interworking Function (PDIF)
S-GW Paging Profile Configuration Mode Commands
▀ ipv4 | ipv6
▄ Command Line Interface Reference, StarOS Release 18
8708
ipv4 | ipv6
Enables operators to specify a 3-tuple lookup (source IP address, source port and protocol) on the inner IP packet of the
GTPU data packet at the S-GW. This configuration is to support the Separate Paging for IMS Service Inspection feature
on the S-GW.
GTPU data packet at the S-GW. This configuration is to support the Separate Paging for IMS Service Inspection feature
on the S-GW.
Product
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration > S-GW Paging Profile Configuration
configure > sgw-paging-profile three tupple
Entering the above command sequence results in the following prompt:
[local] host_name(sep-paging-default)#
Syntax
[ no ] { [ ipv4 ipv4_address | ipv6 ipv6_address ] port source_port_num protocol { [ tcp
| udp ] } paging-identifier integer
| udp ] } paging-identifier integer
no
Removes the specified paging profile configuration.
ipv4
ipv4_address
Specifies the IPv4 address to use for Separate Paging for IMS. Must be in IPv4 address format.
ipv6
ipv6_address
Specifies the IPv6 address to use for Separate Paging for IMS. Must be in IPv6 address format.
port
source_port_num
Specifies the source port on the S-GW to use for Separate Paging for IMS. Must be an integer from 1 to
65535.
65535.
protocol
tcp | udp
Specifies the protocol type to which this SGW paging profile applies. Must be either
tcp
or
udp
.
paging-identifier
integer
Specifies a service identifier for this SGW paging profile (for example, Data 0, VoLTE 1, RCS 2, and so on).
Must be an integer from 0 to 255.
Must be an integer from 0 to 255.