Cisco Cisco Packet Data Interworking Function (PDIF)
Command Line Interface Reference, StarOS Release 18 ▄
8741
Chapter 308
SLs Service Configuration Mode Commands
The SLs interface is used to convey Location Services Application Protocol (LCS-AP) messages and parameters
between the MME to the E-SMLC. It is also used for tunnelling LTE Positioning Protocols (LPP between the E-SMLC
and the target UE, LPPa between the E-SMLC and the eNodeB), which are transparent to the MME.
between the MME to the E-SMLC. It is also used for tunnelling LTE Positioning Protocols (LPP between the E-SMLC
and the target UE, LPPa between the E-SMLC and the eNodeB), which are transparent to the MME.
Mode
Exec > Global Configuration > Context Configuration > SLs Service Configuration
configure > context context_name > sls-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sls-service)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).