Cisco Cisco Packet Data Interworking Function (PDIF)
Subscriber Configuration Mode Commands
▀ long-duration-action
▄ Command Line Interface Reference, StarOS Release 18
8886
long-duration-action
Specifies what action is taken when the long duration timer expires.
Product
All
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
long-duration-action { detection | disconnection [ dormant-only ] [ suppress-notification
] }
] }
detection
Default: Enabled
Detects long duration sessions and sends SNMP TRAP and CORBA notification. This is the default behavior.
Use this command to detect a session exceeding the limit set by the long duration timer.
Detects long duration sessions and sends SNMP TRAP and CORBA notification. This is the default behavior.
Use this command to detect a session exceeding the limit set by the long duration timer.
disconnection [ dormant-only ] [ suppress-notification ]
Default: Disabled
Detects a long duration session and disconnects the session after sending SNMP trap and CORBA
notification.
Detects a long duration session and disconnects the session after sending SNMP trap and CORBA
notification.
suppress-notifiaction
: Suppresses the SNMP trap and CORBA notification after detecting and
disconnecting a long duration session. Default: Disabled
dormant only
: Disconnects the dormant sessions after long duration timer and inactivity time with idle
time-out duration expires. If the long duration timeout is fired and the call is not dormant, the call is
disconnected when the call later moves to dormancy.
disconnected when the call later moves to dormancy.
Important:
For HA calls, the inactivity-time is considered as gauge for dormancy.
It sends the SNMP trap and CORBA notification after disconnecting a long duration session. Default:
Disabled
Disabled
Usage
Use this command to determine what action is taken when a session exceeds the limit set by the long duration
timer.
timer.
Example
Use the following command to enable disconnecting sessions that exceed the long duration timer:
long-duration-action disconnection