Cisco Cisco Packet Data Interworking Function (PDIF)
Subscriber Configuration Mode Commands
▀ pdif mobile-ip
▄ Command Line Interface Reference, StarOS Release 18
8916
pdif mobile-ip
Configures PDIF subscriber call setup parameters.
Product
PDIF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
[ default | no ] pdif mobile-ip { release-tia | required | simple-ip-fallback }
[ default | no ]
Disables the option specified.
release-tia
Specifies that after subscriber call setup is complete, the tunnel inner address (TIA) is released. If SImple IP
is enabled, the TIA becomes the principal communications tunnel and the restriction that it is only to be used
to set up a Mobile-IP call is lifted. This parameter is disabled by default.
is enabled, the TIA becomes the principal communications tunnel and the restriction that it is only to be used
to set up a Mobile-IP call is lifted. This parameter is disabled by default.
required
Specifies that Mobile IP is required for this subscriber whenever a call is set up. This parameter is disabled by
default.
default.
simple-ip-fallback
Specifies that Simple IP should be used when Mobile IP could not be established. This parameter is disabled
by default.
by default.
Usage
Use this command to configure specific behavior for the PDIF subscriber during call setup.
Example
The following command enables the system to fall back to Simple IP when Mobile IP fails for this subscriber
during call setup:
during call setup:
pdif mobile-ip simple-ip-fallback