Cisco Cisco Packet Data Interworking Function (PDIF)
Subscriber Configuration Mode Commands
▀ radius accounting
▄ Command Line Interface Reference, StarOS Release 18
8944
radius accounting
Sets the RADIUS accounting parameters for the subscriber or domain. This command takes precedence over the similar
Context Configuration command and is disabled by default.
Context Configuration command and is disabled by default.
Product
All
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
radius accounting { interim { interval-timeout timeout | normal | suppress } | ip remote-
address list-id list_id | mode { session-based | access-flow-based { none | auxillary-
flows | all-flows | main-a10-only } } | start { normal | suppress } | stop { normal |
suppress } }
address list-id list_id | mode { session-based | access-flow-based { none | auxillary-
flows | all-flows | main-a10-only } } | start { normal | suppress } | stop { normal |
suppress } }
no radius accounting { ip remote-address list-id list_id | interim [ interval-timeout ] }
interim { interval-timeout timeout | normal | suppress }
interval-timeout timeout
: Indicates the time (in seconds) between updates to session counters (log file
on RADIUS or AAA event log) during the session.
timeout
must be an integer from 50 to 40000000.
Caution:
Interim interval settings received from the RADIUS server take precedence over this setting on the
system. While the low limit of this setting on the system is a minimum of 50 seconds, the low limit setting on the
RADIUS server can be as little as 1 second. To avoid increasing network traffic unnecessarily and potentially reducing
network and system performance, do not set this parameter to a value less than 50 on the RADIUS server.
RADIUS server can be as little as 1 second. To avoid increasing network traffic unnecessarily and potentially reducing
network and system performance, do not set this parameter to a value less than 50 on the RADIUS server.
normal
: If RADIUS accounting is enabled, sends this Acct-Status-Type message when required by normal
operation
suppress
: If RADIUS accounting is enabled, suppresses the sending of this Acct-Status-Type message.
ip remote-address list-id list_id
Specifies the identification number of the IP address list to use for the subscriber for remote address-based
accounting.
accounting.
list_id
: Specifies the RADIUS accounting remote IP address list identifier for remote-address accounting
for the subscriber.
list_id
must be an integer from 1 through 65535.
This command is used as part of the Remote Address-based accounting feature and associates the subscriber
with a list of remote addresses. Remote address accounting data is collected each time the subscriber
communicates with any of the addresses specified in the list.
Remote address lists are configured using the
with a list of remote addresses. Remote address accounting data is collected each time the subscriber
communicates with any of the addresses specified in the list.
Remote address lists are configured using the
list
keyword in the
radius accounting ip remote-
address
command in the Context Configuration mode.