Cisco Cisco Packet Data Interworking Function (PDIF)
TWAN Profile Configuration Mode Commands
▀ access-type
▄ Command Line Interface Reference, StarOS Release 18
9034
access-type
This command allows you to specify the access-type for the RADIUS client or specify a default access type for all
RADIUS clients under a TWAN profile.
RADIUS clients under a TWAN profile.
Product
SaMOG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > TWAN Profile Configuration
configure > context context_name > twan-profile twan_profile_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-twan-profile)#
Syntax
access-type client { ipv4 | ipv6_address[/mask ] } { eogre | ip | pmip }
access-type { eogre | ip [ vrf vrf_name ]| pmip }
no access-type { client { ipv4/ipv6_address[/mask ] } | eogre | ip [ vrf ] | pmip }
no
Removes the previously configured access type for the TWAN profile.
client { ipv4 | ipv6_address[/mask ] }
Specifies the IP address of the RADIUS client.
ipv4 | ipv6_address
must be an IP address in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal
notation.
mask
must be a subnet mask bit of the IP address. The mask bit is a numeric value which
corresponds to the number of bits in the subnet mask.
ip [ vrf vrf_name ]
Specifies that all RADIUS clients under this TWAN profile will use the Layer 3 IP (L3IP) access type.
vrf
: Specifies to use the VRF name to install the IP flow for L3IP subscriber session.
vrf_name
must be an alphanumeric string between 1 and 63 characters.
eogre
Specifies that all RADIUS clients under this TWAN profile will use the Ethernet over GRE (EoGRE) access
type.
type.
pmip
Specifies that all RADIUS clients under this TWAN profile will use the Proxy Mobile IP version 6 (PMIPv6)
access type.
access type.