Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
▀ ip subscriber-ip-address
▄ Command Line Interface Reference, StarOS Release 18
972
ip subscriber-ip-address
This command allows you to define rule expressions to match the IP address of the subscriber, which will be either the
source or destination address depending on the direction.
source or destination address depending on the direction.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] ip subscriber-ip-address { operator { ipv4/ipv6_address | ipv4/ipv6_address/mask |
address-group ipv6_address } | { !range | range } host-pool host_pool_name }
address-group ipv6_address } | { !range | range } host-pool host_pool_name }
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
operator
: Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
ipv4/ipv6_address
Specifies the subscriber IP address. Depending on the direction of packet this IP address will be either the IP
source address or the IP destination address.
source address or the IP destination address.
ipv4/ipv6_address
must be an IP address in IPv4 dotted-
decimal or IPv6 colon-separated-hexadecimal notation.
ipv4/ipv6_address/mask
Specifies the subscriber IP address with subnet mask bit. Depending on the direction of packet this IP address
will either be the IP source address or the IP destination address.
will either be the IP source address or the IP destination address.
ipv4/ipv6_address/mask
must be an IP
address in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation with subnet mask bit. The
mask bit is a numeric value which corresponds to the number of bits in the subnet mask.
mask bit is a numeric value which corresponds to the number of bits in the subnet mask.