Cisco Cisco ASR 5700
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll call-reject-no-resource interval
▄ Command Line Interface Reference, StarOS Release 17
5738
threshold poll call-reject-no-resource interval
Configures the polling interval over which to measure IP pool utilization.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll call-reject-no-resource intervaldur
default threshold poll call-reject-no-resource interval
default
Restores the specified parameter to its default value (900 seconds).
interval
dur
Default: 900 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
dur
is an integer from 30 through 60000 in multiples of 30.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshCallRejectNoResource
command in this mode.
Example
The following command configures the polling interval to
600
seconds for call reject no-resource threshold:
threshold poll call-reject-no-resource interval 600