Cisco Cisco ASR 5700
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll cscf-service-route-failures interval ▀
Command Line Interface Reference, StarOS Release 17 ▄
5759
threshold poll cscf-service-route-failures interval
Configures the polling interval in seconds over which to count the CSCF service route failures.
Product
SCM
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll cscf-service-route-failures interval duration
default threshold poll cscf-service-route-failures interval
default
Uses the default threshold polling interval.
Default: 300 seconds
Default: 300 seconds
interval
dur
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 60 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshCSCFSvcRouteFailures
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the CSCF service route failures
threshold:
threshold poll cscf-service-route-failures interval 600