Cisco Cisco ASR 5700
WSG Service Configuration Mode Commands
▀ ip
▄ Command Line Interface Reference, StarOS Release 17
8988
The WSG service configuration takes precedence over the equivalent configuration in Subscriber mode
or the template payload.
The WSG service must be restarted to apply the parameters. You restart the service by doing an unbind
and bind.
Up to 16 named IPv4 pools can be configured. The list is sorted, and the addresses are allocated from
the first pool in the list with available addresses.
One IPv4 ACL can be configured.
The IPv4 pools will only be used for IPv4 calls.
Example
This command specifies the IPv4 address pool named pool401:
ip address pool name pool401
This command specifies the use of a previously configure DHCPv4 service to allocate IPv4 addresses:
ip address alloc-method dhcp-proxy