Cisco Cisco Packet Data Gateway (PDG)
ACS Ruledef Configuration Mode Commands
www reply code ▀
Command Line Interface Reference, StarOS Release 17 ▄
1239
www reply code
This command allows you to define rule expressions to match WWW reply code arguments.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] www reply code operator reply_code
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
reply_code
Specifies the reply code to match.
reply_code
must be an integer from 100 through 599.
Usage
Use this command to define rule expressions to match HTTP 1.1 status code, or WSP status code that has
been remapped to the corresponding HTTP value.
WSP status codes 0 – 101 are automatically remapped to the HTTP status code values, as defined by Table 36
WAP-230-WSP Version 5.
been remapped to the corresponding HTTP value.
WSP status codes 0 – 101 are automatically remapped to the HTTP status code values, as defined by Table 36
WAP-230-WSP Version 5.
Example
The following command defines a rule expression to analyze WWW user traffic based on reply code of
125
:
www reply code = 125