Cisco Cisco Packet Data Gateway (PDG)
BGP Address-Family (IPv4/IPv6) Configuration Mode Commands
timers bgp ▀
Command Line Interface Reference, StarOS Release 17 ▄
1621
timers bgp
Enables or disables an aggressive minimum BGP route advertisement interval (MinRtAdvInterval) for ICSR
configurations.
configurations.
Product
All products that support ICSR
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > BGP Configuration > BGP Address-Family Configuration
configure > context context_name > router bgp as_number > address-family
address_family_type
address_family_type
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-bgp-af-v6)#
Syntax
[no] timers bgp icsr-aggr-advertisement-interval seconds
no
Disables this aggressive ICSR BGP advertisement interval.
seconds
Sets the number of seconds as an integer from 0 to 30. Default: 0.
Usage
Use this command to configure an aggressive ICSR BGP advertisement interval (MinRtAdvInterval). The
default value is 0. If set as 0, the aggressive advertisement interval is disabled.
The MinRtAdvInterval can be uniquely set for each address family.
After ICSR switchover, BGP will set the advertisement-interval for each AFI/SAFI (Address Family
Identifier/Subsequent Address Family Identifier) supported by the peer to the configured value. BGP updates
will be advertised to the peer based on this interval.
default value is 0. If set as 0, the aggressive advertisement interval is disabled.
The MinRtAdvInterval can be uniquely set for each address family.
After ICSR switchover, BGP will set the advertisement-interval for each AFI/SAFI (Address Family
Identifier/Subsequent Address Family Identifier) supported by the peer to the configured value. BGP updates
will be advertised to the peer based on this interval.
Example
The following command sets the MinRtAdvInterval for this address family to 1 second:
timers bgp icsr-aggr-advertisement-interval 1